Advantech PCA-6743 Startup Manual page 3

JWDT1 Watchdog timer output selection
Setting Function
1-2 IRQ11
2-3 System reset
JOBS1 HW Monitor Alarm
Setting Function
1-2 Closed Enable OBS alarm
1-2 Open Disable OBS alarm
SW1
SW STATE SETTING
SW1-1 0 TFT
1 DSTN
SW1-2 0 FPCLK Normal
1 FPCLK Inverted
SW1 0 0 640 x 480
4:3 0 1 800 x 600
1 0 1024 x 768
1 1 1280 x 1024
SW1 0 0 0 9-BIT TFT
7:6:5 001 12-BIT TFT
010 18-BIT TFT
011 24-BIT TFT
100 12X2 - BIT TFT
101 ANALOGTFT
110 18X2 - BIT TFT
SW1-8 0 16-BIT DSTN
1 24-BIT DSTN
Locating Connectors and Jumpers
1 2 3
1 2 3
1 2
1 2
Software Installation
The CD disc contains a driver installer program that will lead
you through the installation of various device drivers needed
to take full advantage of your CPU card.
Caution
Caution! The computer is provided with a battery-powered
Safety Information
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions.
1.
2.
Jumper and Connector Locations (component side)
Jumper and Connector Locations (solder side)
real-time clock circuit. There is a danger of explo-
sion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended
by Advantech. Discard used batteries according
to manufacturer's instructions.
This device may not cause harmful interference.
This device must accept any interference received,
including interference that may cause undesired opera-
tion.
PCA-6743 Startup Manual 3