Maintenance / replacement
26
55
6
6
End cover
55
Allen head screw
Screw out the allen head screws (3 pieces) from the end cover at the bottom of
the turbopump.
Remove the end cover. Pay attention to O-ring.
7
15
7
Operating fluid reservoir
15
Splash nut
Pull the operating fluid reservoir out of the bearing mounting.
Using tweezers, pull out Porex rods (9 pieces).
Remove impurities from the turbopump and the end cover with a clean, lint-free
cloth. Do not use any cleaning fluids!
Using tweezers, insert new Porex rods (9 pieces).
Insert the new operating fluid reservoir with its felt side towards the splash nut
into the bearing mounting.
For the HiPace™ turbopumps the operating fluid reservoir can be pushed up
against into the bearing cartridge.
Screw in the end cover with the new O-ring.
– Tightening torque 2.5 Nm.
6
7
7
Operating fluid reservoir
7a
7a
Porex rod