Start-Up Mode; Keypad Functions - Raymarine ST7002 Operating Manual

Chapter 1: SmartPilot Operation
When the power supply is switched off, the SmartPilot controller buttons have no
effect.
Notes: (1)

Start-up mode

The SmartPilot always powers up in Standby mode with the display showing the
boat's current compass heading.
You can press
Note:

Keypad functions

The SmartPilot is controlled using simple push-button operations, all of which are
confirmed with a short beep. In addition to the main single-button functions,
there are several dual-button operations.
disp
Press to display data pages
Press for 1 second for lamp adjust
Press for 3 seconds
for contrast adjust
Press for 9 seconds
(in Standby mode)
for power down
When powered
down, press for 1
second to power up
resp
Press to display response level
Press for 1 second for rudder gain
track
Press for Track mode from Auto mode
(if a navigator is connected)
Press to accept waypoint advance
Press for 1 second to skip waypoint
mode
Press to select Wind Vane mode
(if a wind vane is connected)
res'm
Press to resume previous course
Each time power to the SmartPilot controller is switched on, the control-
ler is initially in the on condition. You do not need to use the
button to switch the controller on.
When the SmartPilot controller is on, the operation of the
(2)
will perform other operating functions, as described below.
standby
mode
at any time to return to manual steering.
&
Press to scroll through calibration parameters.
Press to adjust response and gain
standby
Press for Standby mode
Press for 2 seconds
to enter Calibration mode
standby plus auto
Press for Wind Vane mode
(if a wind vane is connected)
disp
disp button
course change keys
-1 = Port 1˚
-10 = Port 10˚
+1 = Starboard 1˚
+10 = Starboard 10˚
-1 plus -10
Press together for
AutoTack to port
+1 plus +10
Press together for
AutoTack to starboard
-1 plus +1
Press together for
response level
-1 plus +1
Press for 1 second
for rudder gain
auto
Press for Auto mode
D5448-3
3