Micropak Ground Theory - Ransburg MICROPAK A11789 Service Manual

MicroPak Controller - Installation
MICROP MICROP AK GROUNDING AK GROUNDING
MICROP MICROP MICROPAK GROUNDING AK GROUNDING AK GROUNDING
THEORY THEORY
THEORY THEORY THEORY
Electrical noise refers to stray electrical signals in
the atmosphere at various signal strengths and
frequencies that can affect the operation of electrical
equipment. One of the best ways to prevent this is
to shield the equipment and cables with a continous
ground envelope, such that any incident noise will
be conducted to earth ground before it can affect
the circuit conductors.
For conductors inside the Evolver MicroPak
Controller, the grounded enclosure provides this
envelope. For the low voltage cable(s) that run
from the controller to the Evolver spray guns, a
shielded cable has been used. The shield consists
of an overall foiled shield in combination with an
overall braided shield. This provides the most
effective shielding, as the foil covers the "holes" in
the braid, and the braid allows for practical 360°
termination at both ends of the cable.
The AC input cord is not shielded, but instead is
directed to an AC line filter in the 24VDC power
supply as soon as it enters the cabinet. This filter
filters out any noise that comes in on the AC line.
For maximum noise immunity the AC line should
connect to the filter as soon as possible after it
enters the cabinet. Additional noise protection can
be provided by running the AC input line to the
controller in grounded conduit, which is the
recommended method and is required by most
codes.
For maximum noise protection any user supplied
input/output (I/O) wiring should be made using
shielded cable or conduit which is connected to
earth ground in a continuous 360° fashion at both
ends. The best way to do this is to use a conductive
connector/fitting at each end of the cable/conduit
that makes contact to the shield/conduit in a full
360° circle around the shield/conduit and makes
contact to the grounded enclosure in the same
fashion. Connecting the drain wire of a shield to a
ground point on or in the cabinet (usually referred
to as pigtailing) is not an effective method of
shielding and can actually make things worse (see
Figure 7).
1 5 1 5 1 5 1 5 1 5
A special cable grommet fitting has been provided
for I/O connector P3 of the controller (see Figure
4). When the nut is tightened, the spring in the
grommet compresses and makes 360° contact
with the braid of the cable. This electrically connects
the cable braid to ground via the connector housing
and controller back panel.
continous continous continous continous
Figure 7: Figure 7:
Figure 7: Figure 7: Figure 7:
Cable Connection Examples Cable Connection Examples
Cable Connection Examples Cable Connection Examples Cable Connection Examples
CP-06-01