Changing Of Grinding Belt - KEF PSD 5 Instruction Manual

3.2

Changing of grinding belt

When the grinding belt is worn out it must be replaced which is done the following
way: The top plate (A) (se fig.: 3.2) on the cover is opened and the handle (B) is
pulled down. This way the pressure on the grinding belt will be lowered (C), so that
it can be dismounted and a new grinding belt can be mounted in reverse order.
Please control that the arrows on the back of the grinding belt run in the same
direction as they point. When the new grinding belt is mounted it is necessary to
adjust by the handle (D) for parallel running. The belt is loosened so that the
telescopearm (E) and top wheel (F) can be turned with until the grinding belt runs
straightly on the contactwheel. After this the handle is fastened (D).
It is only allowed to do this adjustment by pulling the grinding belt with the
hands and NOT with power on the machine.
Fig.: 3.2
There are many kinds of grinding belts so therefore it is very important to choose
the right type of belt. There are many things to consider before choosing the belt:
material to be grinded - grit size - belt material - glue.
In connection to this we can tell you that there are different kinds of contact wheels
with various softnes and shapes for different purposes.
8