Belt Arm; Assembly And Mounting Of Belt Arm - KEF PSD 5 Instruction Manual

3 Belt Arm

3.1

Assembly and mounting of belt arm

If the grinding machine is mounted with a grinder cover or a deburrer cover these must be
removed completely before mounting the belt arm.
Mount the telescopearm (A) to the cover (B) by using the fitting for the telescope arm (C)
and mounting the cover (B) by putting a screw through the side plate into the holder for the
telescopearm (D). The topwheel (E) must be inside the cover (B).
The fitting for the telescopearm (C) is not alloved to be fastened harder than it is
still possible to adjust the direction of the grinding belt.
The belt arm can be tilted to the wanted inclination. After this the holder for the
telescopearm (D) is fastened by tightening the two screws placed in the ring on the
holder. The flanges, contact wheel and the reserve nut are now put in (pls. see the
drawing of belt arm for order). Please make sure that the top wheel (E) and the
contact wheel run parallelly. The position of the contact wheel can be adjusted with
the distance rings attached.
The topwheel (E) can be loosened and adjusted so that it fits the wanted grinding
belt lenght. The same way you can tighten the grinding belt.
7
Fig.: 3.1