E66: Heater Relay Problem; E68: Current Leakage To Ground On Heater Or Wiring; E69: Heater Open; E6A: Heater Relay Sensing Problem - Electrolux EFLS617SIW Technical & Service Manual

Troubleshooting Based on Error Codes

E66: Heater Relay Problem

E66
Heating Element defective, Wiring problem.

E68: Current Leakage to Ground on Heater or Wiring

E68
Current Leakage to Ground on Heater or Wiring.

E69: Heater Open

E69
Heating Element defective, Wiring problem.

E6A: Heater Relay Sensing Problem

E6A
Heating Element defective, Wiring problem.
Checks to perform:
(Not applicable for 417 series)
Check if the resistance between the terminals
of Heating Element is approximately 14 Ω ± 5%?
(See Fig. 1)
Check if the resistance of Heating Element near
Main Control Board side (between J5-1 and J5-2) is
approximately 14 Ω ± 5%? (See Fig. 2)
Check the resistance between ground and both
heater terminals when the heater terminals are
disconnected. Is resistance value not "0"? (See Fig. 3)
Replace the Main Control Board, and repeat the
diagnostic cycle to check for any further errors.
Y
E
S
Y
E
S
Y
E
S
WARNING
Check that all the connectors are correctly
inserted.
Replace the Heating Element, and repeat the
NO
diagnostic cycle to check for any further errors.
Replace the wiring, and repeat the diagnostic
NO
cycle to check for any further errors.
Replace the Heating Element, and repeat the
NO
diagnostic cycle to check for any further errors.
50
E66
E68
E69
E6A