Table of Contents
Advertisement
Problem
The washing results
are not satisfactory.
Too much foam in
the drum during the
washing cycle.
After the washing cy‐
cle, there are some
detergent residues in
the dispenser drawer.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
15. TECHNICAL DATA
Dimension
Electrical connection
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
Water supply pressure Minimum
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
16. PROBLEM WITH MAINS SUPPLY
A momentary or a long interruption of
power supply stops the washing machine
operating, especially when the load on
electrical network exceeds the maximum
Possible solution
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Reduce the quantity of detergent.
• Make sure that the flap is in the correct position.
• Make sure you have used the detergent dispenser accord‐
ing the indications given in this user manual.
Width/ Height/ Total
depth
Voltage
Overall power
Fuse
Frequency
Maximum
1)
Cotton
Maximum spin speed
400 mm/ 890 mm/ 600 mm/ 600
mm
230 V
2200 W
10 A
50 Hz
IPX4
0.5 bar (0.05 MPa)
10 bar (1.0 MPa)
Cold water
6 kg
A+++
1251 rpm
nominal load, 2000 watts. This can
decrease the voltage supply below the
acceptable values, 185 volts.
ENGLISH
33
Advertisement
Table of Contents
