E62: Wash Temperature Too High - Electrolux EFLS617SIW Technical & Service Manual

E62: Wash Temperature Too High

E62
NTC defective, Wiring problem.
Checks to perform:
(Not applicable for 417 series)
Is the resistance measurement of the Drum water NTC ranges from
4.5 KΩ to 5.5 KΩ at 25 °C? (Measure it directly on the Drum water
NTC without wiring.) (See Fig. 1)
Reconnect the connector and measure the resistance ranges
from 4.5 KΩ to 5.5 KΩ at 25 °C. On the Drum water NTC wiring
connector on the Main Control Board between J12-4 and J12-5, Is
the Inlet NTC Valve wiring OK? (See Fig. 2)
Check if the resistance between the terminals of Heating Element is
approximately 14 Ω ± 5%? (See Fig. 3)
Check the resistance between ground and both heater terminals
when the heater terminals are disconnected. Is Resistance value
Replace the Main Control Board and repeat the diagnostic cycle
to check for any further errors.
Troubleshooting Based on Error Codes
Y
E
S
Y
E
S
Y
E
S
not "0"? (See Fig. 4)
Y
E
S
WARNING
Check that all the connectors are correctly
inserted.
NO
Replace the wiring, and repeat the
NO
Replace the Heating Element and
NO
repeat the diagnostic cycle to check
Replace the Heating Element and
repeat the diagnostic cycle to check
NO
49
Replace the NTC, and repeat the
diagnostic cycle to check for any
further errors.
diagnostic cycle to check for any
further errors.
for any further errors.
for any further errors.
E62