ProSoft Technology inRAx MVI46-GEC User Manual page 13

Start Here
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
Turn power OFF.
1
Align the module with the top and bottom guides, and slide it into the rack
2
until the module is firmly against the backplane connector.
With a firm but steady push, snap the module into place.
3
Check that the holding clips on the top and bottom of the module are securely
4
in the locking holes of the rack.
Make a note of the slot location. You will need to identify the slot in which the
5
module is installed in order for the sample program to work correctly. Slot
numbers are identified on the green circuit board (backplane) of the SLC
rack.
Turn power ON.
6
Note: If you insert the module improperly, the system may stop working, or may behave
unpredictably.
ProSoft Technology, Inc.
April 30, 2008
MVI46-GEC ♦ SLC Platform
Generic ASCII Ethernet Interface Module
Page 13 of 78