Using Your Ceiling Fan; Installing The Wall Control - Emerson EUCLID CF500AP00 Owner's Manual

6. Installing the Wall Control

6.3
Attach the SW46W Fan Control to the wall outlet box with
two 6-32 x 3/4" screws (provided with control).
Position the faceplate (provided with control) onto the
speed control. Using the two 6-32 x 1/4" screws, screw the
faceplate and speed control to the wall outlet box
(Figure 24).
Restore power at the main fuse box or circuit breaker
panel.
7.1
IMPORTANT
Fan installation must be completed, including the
installation of the fan blades, before testing of the
controls.
Restore electrical power to the outlet box by turning the
electricity on at the main fuse box.
Check the operation of the fan by sliding the bar of the
control through the four positions marked 1 - 4
("0" position is OFF) (Figure 25).
7.2
All fans are shipped from the factory with the reversing
switch positioned to circulate air downward. If airflow is
desired in opposite direction, turn your fan OFF and wait
for the blades to stop turning, then slide the reversing
switch to the opposite position, and turn fan on again
(Figure 26).
The fan blades will turn in the opposite direction and
reverse the airflow.
Reverse Switch Information
Summer Counter-Clockwise
Season Rotation Direction
Winter Clockwise

7. Using Your Ceiling Fan

Right
Switch Position
Left
16
(Continued)
WALL OUTLET BOX
SW46 F AN CONTROL
6-32 x 1/4" SCREWS (2)
Figure 24
SPEEDS and OFF:
4 - High
3 - Medium High
2 - Medium
1 - Low 4
0 - OFF
3
2
1
0
Figure 25
REVERSING
SWITCH
Figure 26
4
3
2
1
0
6-32 x 3/4"
SCREWS (2)
F ACEPLATE
Slide the switch up and
down to select the
desired operating speed
or to turn the fan OFF
SLIDE SWITCH
U.L. Model No.: CF500