UEi EAGLE C125 Quick Start Manual

Sensor calibration & replacement

Download this manual

C125 & C127 S

Calibration Instructions;

Note: Disclaimer of Liability

These instructions are prepared for use by trade professionals familiar with gas analysis and detection,

and are familiar or have experience in calibrating gas measurement systems. They are intended to be

as complete and simple as possible to eliminate the chance for error. Certain factors related to analyzer

field recalibration are beyond the control of UEi, and the user should be aware of these factors such as

proper delivery of gas to the analyzer during calibration, the age of the calibration gas, and the accura-

cy of the calibration gas.

By using these instructions to recalibrate your instrument, you assume all risks and liability associated

with the measurement of carbon monoxide (CO) gas concentrations.

Indemnification

To the extent permitted by applicable law, by using these instructions to recalibrate your analyzer, you

agree to defend, indemnify, and hold harmless, UEi, its agencies, officers, employees, representatives,

and agents from and against all claims and expenses, including attorneys' fees, arising out of the use of

this material.

& R

ENSOR

ALIBRATION

UICK

TART

UIDE

Visit us at www.TestEquipmentDepot.com

EPLACEMENT

99 Washington Street

Melrose, MA 02176

Phone 781-665-1400

Toll Free 1-800-517-8431

Page 1 Certain factors related to analyzer field recalibration are beyond the control of UEi, and the user should be aware of these factors such as proper delivery of gas to the analyzer during calibration, the age of the calibration gas, and the accura- cy of the calibration gas.
Page 2 ENSOR EPLACEMENT 1. Tools required to replace the 2. Remove the protective boot 3. Remove the water trap by 4. Remove the batteries. sensor include a standard from the instrument. sliding down and then away Phillips screw driver and a from the housing.
Page 3 b. Note the position of the 12. Install the sensor to be 13. Reinstall sensor cover. 14. Set circuit board back on alignment pin on the O2 replaced. manifold. a. Verify that the sensor cover and pin orientation on the is seated on the manifold a.
Page 4 Slight fluctuation of display 99 Washington Street is normal. Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com COPYRIGHT © 2007 UEi. EAGLE Combustion Analyzers™ is a trademark of UEi. CALKIT-MAN 11/07...

Eagle c127