Table of Contents
Advertisement
5 SERVICE AND MAINTENANCE
It cannot be emphasised often enough how much proper service and maintenance influence performance
reliability and service life of a machine.
WARNING!
The best way to clean the interior of pipes and fittings is to pump water through the system for a short while.
The pump should be stored in a weather-protected place under a roof, if possible. In areas where frost is likely
during the winter season the pump housing must be drained completely by turning out the drain plugs located at
the lowest points of the housing.
Observe local laws and regulations when disposing of pumps and pump components after repairs and service
or when a pump is withdrawn from service. This applies in particular to the treatment of residual slurry in the
pump body.
6 TECHNICAL DATA
Output
kW
Discharge capacity
m
Manometric head
m
Impeller speed
rpm
Power required
kW
Oil capacity
Engine Oil; Viscosity Grade SAE20W20 or SAE20; SAE HD30; Quality Level API CF/SF
Operating manual BAUER Submersible Motor Pump / Version X-2010
The pump and all its accessories should be cleaned immediately after use. As long
as the slurry has not dried up it can easily be rinsed off with water.
4
3
20 - 140
/h
9,5 - 3
1440
3,3 - 4,2
5,5
7,5
20 - 160
20 - 190
12,5 - 3,5
18 - 5
1445
1450
3,7 - 5,2
4,6 - 7,1
3,5 l motor oil- SAE 20 W-20 (SAE HD 30)
11
15
20 - 220
20 - 240
20 - 5
21 - 5
1400
1450
7,4 - 11,3
8 - 11,4
16
Advertisement
Table of Contents
