Carrier 42HWG009 Technical Data & Service Manual page 63

P R O C E D U R E S
5. Removing the indoor coil.
(1) Turn the unit over and you will find one screw for insert
b o d y .
(2) Remove one screw and detach insert body. (fig. 7)
(3) Turn the unit over again and remove three screws from
the coil.
(4) Detach coil by pulling the snap-fit out from the unit.
(fig. 8)
6. Removing blower and fan motor.
(1) Detach bearing bracket by removing one screw from
the body. (fig. 9)
(2) Loosen a set-screw inside the blower with hex key
wrench(M3). (fig. 10)
(3) Pull the blower out.
(4) Detach motor bracket L and R by removing two
screws from the body. (fig. 11)
(5) Pull the motor out.
Fig. 5
Fig. 7
62
P H O T O S
Fig. 6
Fig. 8
Fig. 9
Fig. 10
Fig. 11