Carrier 42HWG009 Technical Data & Service Manual page 13

FAN SPEED SELECTING BUTTON
Press this button to select the desired fan speed.
The indoor fan will operate at the selected fan speed. (AUTO, LOW, MED, HIGH)
When you select "AUTO", the fan speed is controlled by microcomputer of the unit.
FLAP CONTROL BUTTON
Controls the discharge air flow direction up and down.
• In the beginning, the flaps open properly according to the operating mode.
• If you press this button, the flap will move stepwise and the position will be dis-
played.
• If you press this button again, the unit will operate at "SWING". The flap will swing up
and down continuously at "SWING".
ON/OFF TIMER AND CURRENT TIME BUTTONS
• Set the desired time for the unit control with these buttons.
• If you set ON and OFF time, the unit will be automatically turned on and off at the set
time.
• Press current time button when you want to know the current time, and the current
time is indicated.
HOUR/MINUTE SETTING BUTTONS
Adjust current time and ON/OFF timer with these buttons.
SET AND CANCEL BUTTONS
Press SET button to reserve ON/OFF timer and if you want to cancel the reserved
time, use CANCEL button.
EVERYDAY TIMER BUTTON
Press this button at the reserved condition of the combined ON and OFF timer in
order to repeat the combined ON and OFF timer reservation everyday until the
reservation is canceled.
CURRENT TIME ADJUSTING BUTTON
Press this button to adjust the current time.
RESET BUTTON
Press this button when the remote control is not operating properly or after replacing
batteries.
ADDRESS SWITCH
If there are two indoor units in the same room, link one remote control with one indoor
unit, and link the other remote control with the other indoor unit.
12