Sensors & Zones: Configure Wireless Sensors Screen - Technicolor TCA203 Installation Manual

Figure 32: Sensors & Zones: Configure Wireless Sensors Screen
10. If all of the sensors have not been configured, the TouchScreen displays the Modify screens for
each sensor to allow you to review its details. Modify the details as needed or tap Next to cycle
through all the sensors.
The wireless sensors are marked as configured.
11. From this point you can configure any or all of the following devices:
Panel Interfaces (see
face Modules to the Security System on page
Cameras (see Step G: Adding Cameras to the
Security System on next
Lights (see Step H: Adding Lighting Devices to the
Security System on page
After all the devices are configured—or if you want to configure the devices later—tap Next to go to
M: Testing the Alarm Functionality of the Security System on page
Step E: Adding Panel Inter-
24)
page)
47)
Installing the Security System
Thermostats (see Step I: Adding a Ther-
mostat to the Security System on page
50)
Key Fobs (see Step J: Adding Key Fobs to
the Security System on page
Key Pads (see Step K: Adding Key Pads
to the Security System on page
65.
53)
57)
Step
37