Chapter 20 Appendix; Sar And Certification Information - Fujitsu F-022 User Manual

Table of Contents

Advertisement

F-022_E2kou
F-022.book 68 ページ 2011年2月24日 木曜日 午後2時42分
Chapter 20 Appendix

20.1 SAR and Certification Information

For further information about Specific Absorption Rate (SAR),
please see the website below:
World Health Organization (WHO): http://www.who.int/peh-emf/
◆ Declaration of Conformity
The product "F-022" is declared to conform with the essential
requirements of European Union Directive 1999/5/EC Radio and
Telecommunications Terminal Equipment Directive 3.1(a), 3.1(b)
and 3.2. The Declaration of Conformity can be found in this
manual.
This mobile phone complies with the EU requirements for
exposure to radio waves.
Your mobile phone is a radio transceiver, designed and
manufactured not to exceed the SAR* limits** for exposure to
radio-frequency(RF) energy, which SAR* value, when tested for
compliance against the standard was x.xxxW/Kg. While there may
be differences between the SAR* levels of various phones and at
various positions, they all meet*** the EU requirements for RF
exposure.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
*
The exposure standard for mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
68
** The SAR limit for mobile phones used by the public is 2.0 watts/
kilogram (W/ Kg) averaged over ten grams of tissue, recommended
by The Council of the European Union. The limit incorporates a
substantial margin of safety to give additional protection for the
public and to account for any variations in measurements.
*** Tests for SAR have been conducted using standard operation
positions with the phone transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR
level of the phone while operating can be well below the maximum
value. This is because the phone is designed to operate at multiple
power levels so as to use only the power required to reach the
network. In general, the closer you are to a base station antenna,
the lower the power output.
◆ Federal Communications Commission (FCC)
Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions :
a this device may not cause harmful interference, and
b this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications made in or to the radio phone, not
expressly approved by the manufacturer, will void the user's
authority to operate the equipment.

Advertisement

Table of Contents
loading

Table of Contents