Table of Contents
Advertisement
F-022_E2kou
F-022.book 5 ページ ２０１１年２月２４日 木曜日 午後２時４２分
*4 Code IP5X means that a device is protected against the ingress of
dust specific to dustproof test (25
that the ingress will not interfere with predefined operation and
safety of the device.
F-022 provides the following waterproof performances of IPX8.
• F-022 keeps functioning after it is slowly submerged to depth
of 1.5m in static tap water at room temperature, left there for
30 minutes and then taken out.
• The mobile phone keeps shooting still images or moving
pictures in 30 minutes in static tap water at room temperature.
❖
What you can do with waterproofness and
dustproofness of F-022
You can talk without using an umbrella in the rain (for rainfall of
･
20 mm or less per hour).
- When your hands or F-022 terminal are wet, avoid installing/
removing the rear cover or opening/closing the external
connection jack cap.
You can also shoot still images and moving pictures in the pool
･
depth of 1.5 m.
- Do not perform other operations underwater than shooting still
images and moving pictures.
- If you put the terminal in water of swimming pool, be sure to
have it within 30 minutes.
- If F-022 terminal gets wet with water from the swimming pool,
wash it as predefined.
You can use F-022 terminal in a bathroom.
･
- Do not put the terminal in the bathtub. Do not use the terminal
in hot water. Doing so may cause malfunction.
- Never put F-022 terminal in hot spring water or water containing
soap, detergent or bath powder.
µ
m or smaller in diameter), so
◆ To ensure waterproofness/dustproofness
To avoid water and dust ingress, be sure to observe the following
points.
Do not throw any liquid other than room-temperature tap water
･
on F-022 terminal, or soak it in such liquid.
･
Open/close the external connection jack cap as described below.
<Opening the external connection jack cap>
Place your finger at groove on the hinge side to open the cap.
Groove on the hinge side
<Closing the external connection jack cap>
Close with the tab for the rear cover at the rear side of the cap fitted
into the concave of this terminal. Make sure that the cap is
completely closed without slack.
Install the rear cover as described below.
･
Tab on the rear
cover side
5
Chapter 1 Introduction
Advertisement
Table of Contents
