Configuring Additional Management Interfaces - AudioCodes Mediant 4000 SBC User Manual

User's Manual
6.3

Configuring Additional Management Interfaces

The Additional Management Interfaces table lets you configure up to 16 management
interfaces, in addition to the OAMP management interface in the IP Interfaces table.
Multiple management interfaces lets you access the device's management interfaces (e.g.,
Web interface and CLI) remotely through different IP addresses. Each additional
management interface can be configured to use a specific network interface (Control
and/or Media type) and TLS Context, and can be configured to restrict access through
HTTPS only.
Note:
•
To allow access to the device's management interfaces through all network
interfaces in the IP Interfaces table, see the EnableWebAccessFromAllInterfaces
parameter. This parameter does not specify a TLS Context nor a connectivity
protocol (HTTP or HTTPS).
•
Currently, additional management interfaces are not supported for REST API
(ARM).
The following procedure describes how to configure additional management interfaces
through the
(AdditionalManagementInterfaces) or CLI (configure system > additional-mgmt-if).

To configure additional management interfaces:
1. Open the Additional Management Interfaces table (Setup menu > Administration tab
> Web & CLI folder > Additional Management Interfaces).
2. Click New; the following dialog box is displayed:
Figure 6-28: Additional Management Interfaces Table - Add Dialog Box
3. Configure an additional management interface according to the parameters described
in the table below.
4. Click Apply, and then save your settings to flash memory.
Additional Management Interfaces Table Parameter Descriptions
Parameter
General
Version 7.2
Web interface. You can also configure
Description
69
6. Web-Based Management
it through ini
Mediant 4000 SBC
file