Viewing Current Cli Sessions - AudioCodes Mediant 4000 SBC User Manual

Family of session border controllers, sbc
Hide thumbs Also See for Mediant 4000 SBC:
Table of Contents

Advertisement

User's Manual
Telnet: The device can be accessed through its Ethernet interface by the Telnet
protocol using Telnet client software.
The following procedure describes how to access the CLI through Telnet/SSH.
Note:
interfaces (such as Web interface). The default username and password is "Admin"
and "Admin" (case-sensitive), respectively. To configure login credentials and
management user accounts, see ''Configuring Management User Accounts'' on page
70.
To establish a CLI session with the device:
1.
Connect the device to the network.
2.
Establish a Telnet or SSH session using the device's OAMP IP address.
3.
Log in to the session using the username and password assigned to the Admin user of
the Web interface:
a.
At the Username prompt, type the username, and then press Enter:
Username: Admin
b.
At the Password prompt, type the password, and then press Enter:
Password: Admin
c.
At the prompt, type the following, and then press Enter:
> enable
d.
At the prompt, type the password again, and then press Enter:
Password: Admin
7.4

Viewing Current CLI Sessions

You can view users that are currently logged in to the device's CLI. This applies to users
logged in to the CLI through RS-232 (console), Telnet, or SSH. For each logged-in user,
the following is displayed: the type of interface (console, Telnet, or SSH), username,
remote IP address from where the user logged in, and the duration (days and time) of the
session. Each user is displayed with a unique index (session ID).
To view currently logged-in CLI users:
1.
Establish a CLI session with the device.
2.
Run the following command:
# show users
[0]
[1]
[2]* ssh
The current session from which this show command was run is displayed with an asterisk
(*).
Note:
time, the duration counter is reset.
Version 7.2
The CLI login credentials are the same as all the device's other management
console
Admin
telnet
John
Alex
The device can display management sessions of up to 24 hours. After this
local
10.4.2.1
192.168.121.234
85
7. CLI-Based Management
0d00h03m15s
0d01h03m47s
12d00h02m34s
Mediant 4000 SBC

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mediant 4000b sbc

Table of Contents