Dns; Configuring The Internal Dns Table - AudioCodes Mediant 4000 SBC User Manual


To configure handling of ICMP messages:
1. Open the Network Settings page (Setup menu > IP Network tab > Advanced folder >
Network Settings).
2. Under the ICMP group, do the following:
•
To enable sending and receipt of ICMP Redirect messages, configure the 'Send
and Received ICMP Redirect Messages' parameter to Enable.
•
To enable sending of ICMP Destination Unreachable messages, configure the
'Send ICMP Unreachable Messages' parameter to Enable.
3. Click Apply.

11.10 DNS

You can use the device's embedded domain name server (DNS) or an external, third-party
DNS to translate domain names into IP addresses. This is useful if domain names are used
as the destination in call routing. The device supports the configuration of the following
DNS types:

Internal DNS table - see ''Configuring the Internal DNS Table'' on page 152

Internal SRV table - see ''Configuring the Internal SRV Table'' on page 153

11.10.1 Configuring the Internal DNS Table

The Internal DNS table, similar to a DNS resolution can translate up to 20 host (domain)
names into IP addresses. This functionality can be used when a domain name (FQDN) is
configured as an IP destination in a routing rule. Up to three different IP addresses can be
assigned to the same host name.
Note: The device first attempts to resolve a domain name using the table. If the
domain name is not configured in the table, the device performs a DNS resolution
using an external DNS server for the related IP network interface (see ''Configuring IP
Network Interfaces'' on page 129).
The following procedure describes how to configure the DNS table through the Web
interface. You can also configure it through ini file (DNS2IP) or CLI (configure network >
dns dns-to-ip).

To configure the device's DNS table:
1. Open the Internal DNS table (Setup menu > IP Network tab > DNS folder > Internal
DNS).
User's Manual
Figure 11-12: Configuring ICMP Messaging
152
Mediant 4000 SBC
Document #: LTRT-42025