Installation And Operation; Installation; Ac Power Considerations; Tilt-Foot Adjustment - ILX Lightwave OMM-6810B User Manual


This chapter describes how to install, adjust, and operate the OMM-6810B. It is
divided into five sections covering installation, power-up, front panel and rear
panel controls, and general operation.
Appendix B, Quick Start, is intended for users who wish to begin operation
immediately. It contains the minimum amount of information required to safely
operate the instrument.

Installation

AC Power Considerations

The device can be configured to operate at nominal line voltages of 100, 120, 220,
or 240 VAC. This configuration is normally done at the factory and need not be
changed before operating the instrument. Ensure the voltage printed on the back
panel of the instrument matches the power-line voltage in your area. Refer to
Chapter 6, Maintenance, should it be necessary to reconfigure the input AC
voltage range.
To avoid electrical shock hazard, connect the instrument to a properly earth grounded,
three prong receptacle only. Failure to observe this precaution can result in severe injury
or death.

Tilt-Foot Adjustment

The instrument has front legs that extend to make it easier to view the display.
Place the OMM-6810B on a stable base and rotate the feet downward until they
lock into position.
I
NSTALLATION AND
2
C H A P T E R
O
PERATION
OMM-6810B

7