Chapter 2 Operation; Installation - ILX Lightwave OMH-6722B User Manual

2
C H A P T E R
O
PERATION

This chapter describes how to install and operate the OMH-6722B Silicon
Power/WaveHead in conjunction with a OMM-6810B Optical Multimeter. It is
divided into sections covering installation, power-up, front panel and rear panel
controls, and general operation. A detailed familiarization of the main unit
features are presented in Chapter 2 of the OMM-6810B Instruction Manual.

Installation

The OMH-6722B must be connected to the 6810B. Make sure the power to the
main unit is turned off and connect the cable from the 6722B to the INPUT
connector on the rear panel of the 6810B.
the
Do not attach or remove the Optical Measurement Head while power is applied to
OMM-6810B. Please turn the power switch off when changing heads.
three
To avoid electrical shock hazard, connect the meter to a properly earth grounded,
prong receptacle only. Failure to observe this precaution can result in severe
injury or death.
5
OMH-6722B 
Downloaded from StockCheck.com