Common Commands; Omm-6810B Device-Dependent Commands - ILX Lightwave OMM-6810B User Manual

Common Commands

The GPIB Common Commands which are defined by the ANSI/IEEE-488.2-1987
standard are described in Chapter 3. These commands do not necessarily reflect
front panel operations but are useful for generic device control. Some of the
common commands are useful for advanced programming techniques, such as
generating service requests (SRQ).

OMM-6810B Device-Dependent Commands

This section contains descriptions of all device-dependent commands for the
6810B, listed in alphabetical order. Sub-sections for each path are presented,
listing all of the commands which are legal for that path. The command path tree
structure is illustrated in Figure 4.2. Descriptions of the common commands and
low level remote interface messages are provided in Chapter 3.
Table 4.1 Device-Dependent Commands
NAME
BRIght
BRIght?
CAL:POWERSET
CAL:RECall
CAL:USER
CAL:WAVESET
COND?
DIS
ENAB:COND
ENAB:COND?
ENAB:EVENT
ENAB:EVENT?
ERRors?
EVEnt?
HEAD:IDN?
HOLD?
POWer?
POWer:AUTO
POWer:AUTO?
POWer:MODE
POWer:MODE?
POWer:OFFSET
POWer:OFFSET?
01_10
C O M M A N D R E F E R E N C E
PARAMETERS FUNCTION
1 Sets the brightness of the front panel
NONE Returns the level of the display brightness
2 Sets the user calibration power
NONE Resets the user calibration
NONE Controls the user calibration
1 Sets the user calibration wavelength
NONE Returns the condition status register
1 Turns the display on or off
1 Sets the enable register for conditions
NONE Returns the value of the condition enable register.
1 Sets the enable register for events
NONE Returns the event enable register
NONE Returns errors generated since the last ERR?
NONE Returns the event status register
NONE Returns the head identification string
NONE Returns the hold status
NONE Returns the power measurement
1 Sets the power autoranging mode on or off
NONE Returns the status of power autoranging
2 Sets the power display units
NONE Returns the power display units
1 Sets the power offset multiplier
NONE Returns the power offset multiplier
Common Commands
OMM-6810B
4
C H A P T E R
51
