Installation; Power And/Or Wavelength Measurement - ILX Lightwave OMM-6810B User Manual



Installation

Ensure the voltage printed on the back panel of the 6810B matches the power-line
voltage in your area. Connect the Optical Measurement Head to the INPUT
connector on the rear panel. Connect the 6810B to the proper AC power
receptacle and press the front panel POWER switch to start the power-up
sequence. To achieve rated stability, let the instrument warm up for 1 hour before
operating.
To avoid electrical shock hazard, connect the instrument to properly earth- grounded,
three prong receptacles only. Failure to observe this precaution can result in severe
injury or death.

Power and/or Wavelength Measurement

The Optical Measurement Head must be connected to the instrument and the
multimeter should be zeroed under nominal test conditions. The beam of the
laser under test should be directed perpendicular to the face of the Measurement
probe or head and directly into the aperture. The following paragraphs describe
front panel operation. Functions change slightly depending on the measurement
head attached.
WARNING
Do not attach or remove Optical Measurement Head while power is applied to the
Multimeter. Please turn the power switch off when changing heads.
A P P E N D I X
Q S
UICK TART
B
G
UIDE
109
OMM-6810B
