Warranty And Safety Guidelines - Band-it UL4000-D Operating Instructions Manual

Cordless ultra-lok tool

Hide thumbs

Table Of Contents

Table of Contents

Refer to website for warranty information:

NOTE: Any performance data published herein is based on laboratory tests, which cannot duplicate conditions that

may be encountered in field installations. Such conditions may vary results substantially from those shown (such as

abuse in handling and installation, failure to follow recommended handling and installation practices, abnormal

environmental conditions, disregard of operating instructions for BAND-IT tools or non-recommended combinations of

BAND-IT products). BAND-IT cannot be responsible for performance characteristics from such variables.

WARNING:

Always wear safety glasses when operating this tool and keep both hands and clothing away from clamp

being tensioned. Squeezing force can reach as high as 2 tons. Never attempt to clamp objects which can

shatter or otherwise cause bodily harm. Tensioning the clamp can be stopped immediately by releasing the

trigger. Detailed instructions are in this manual and the operator is advised to read it and become familiar with

operating the tool.

IMPORTANT FOR HOSE APPLICATIONS:



When clamping a hose end, remember that a tighter clamp keeps the fitting more secure, but excess

tension can damage the hose. Fitting stem must have prominent barbs for proper retention inside the

hose, but must not be sharp to prevent cutting into the hose. Hose, fitting, and clamp must be

compatible with each other and the environment used in. If in doubt, consult the hose or fitting

manufacturer or call BAND-IT.



Improperly tightened clamps may result in dangerous hose assemblies, which could cause injuries or property

damage.



Abuse or use of a hose outside the manufacturers recommended conditions may cause it to quickly deteriorate

and become a safety hazard. This could result in serious injury or property damage. Inspect and test hose

assemblies frequently.

Clamping objects other than hose requires similar precautions.

Use only with BAND-IT 3/4" and 1/2" Ultra-Lok Free-End and Preformed Clamps

This tool is designed to work solely mounted to the Metabo BS 18 LTX series cordless drill. Use of any other drills in

place of these Metabo BS 18 LTX drills may result in unsatisfactory performance, hazards to the operator and/or the

tool, or unsafe clamps. Disregard of this caution voids the warranty of the tool and releases BAND-IT of any and all

liabilities arising from such misuses.

BAND-IT IDEX, Inc.

A Unit of IDEX Corporation

4799 Dahlia Street

Denver, CO 80216-0307 USA

P: 1-800-525-0758

F: 1-800-624-3925