Tool Settings; Band-It Idex, Inc - Band-it UL4000-D Operating Instructions Manual

Drill Model
Clamp Size
Single Wrap
Double Wrap
*Preformed
Band-It recommends hearing protection if this setting is used for an extended time.
NOTE: These torque settings are suggested settings only; individual tools should be adjusted for the
clamping application. Inspect lock per instructions on page 9-11.
Important: Changing speed and clutch settings will alter tension output. Drill Trigger should be depressed fully
by the operator to attain correct, and consistent, tension when installing clamps. Tension output may vary from
tool to tool, at the same setting, depending on condition and wear of internal components.
Caution: Improperly tightened clamps may result in dangerous assemblies, which could cause injuries or
property damage.
Using correctly sized clamps (diameter) will, in most cases, eliminate the need to pull on clamp tail more than
once. Tension Block moves approximately 5". On occasion, if needed, large size clamps can be installed by
taking several bites (clamp tail feeds out through back of tool). Position of Tension Block, containing gripper,
can be monitored through viewing slot just under cut-off handle. The tool features a built-in disengaging
mechanism to prevent tension screw from jamming up. At the end of the Tension Block travel the safety clutch
will engage and the user will hear a ratcheting sound. Excessive use of this feature will wear the Drill Clutch
mechanism and/or Tension Screw out prematurely.
Battery Recommendation: In order to maintain consistent tension when installing clamps, Band-It recommends
that the drill be recharged once the indicator on the battery drops to 1 out of 4.

BAND-IT IDEX, Inc.

A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925

Tool Settings

Recommended Drill Torque Dial Settings:
½"
Speed
1
1
1
www.BAND-IT-IDEX.com
Metabo BS 18 LTX
Clutch Speed
5
6
6
6
UL4000-D
ULTRA-LOK® TOOL
¾"
Clutch
1 6
1 7
1 7
Document # P09986 Rev. B
BAND-IT IDEX, Inc. 2016
All Rights Reserved
© Copyright