Safety Guidelines - Band-it Ultra-Lok UL4000-BUltra-Lok UL4000-B220 Operating Instructions Manual

Table of Contents

Advertisement

Warranty, Safety
Guidelines, Contents
Refer to website for warranty information:
NOTE: Any performance data published herein is based on laboratory tests, which cannot duplicate conditions that may
be encountered in field installations. Such conditions may vary results substantially from those shown (such as abuse in
handling and installation, failure to follow recommended handling and installation practices, abnormal environmental
conditions, disregard of operating instructions for BAND-IT tools or non-recommended combinations of BAND-IT
products). BAND-IT cannot be responsible for performance characteristics from such variables.
When applying clamps, care should be taken to make certain that fingers are not in the way of the clamp being
applied. Tensioning the clamp can be stopped immediately by releasing the trigger. Detailed instructions are in
this manual and the operator is advised to read it and become familiar with operating the tool.
IMPORTANT: When clamping a hose end, remember that a tighter clamp keeps the fitting more secure, but
excess tension could damage the hose. Fitting stem must have prominent barbs for proper retention inside the
hose, but must not be sharp to prevent cutting into the hose. Hose, fitting and clamp must be compatible with
each other and the environment used in. If in doubt, consult the hose or fitting manufacturer or call BAND-IT.
Clamping objects other than hose requires similar precautions.
CAUTION: Improperly tightened clamps may result in dangerous hose assemblies, which could cause injuries or
property damage.
CAUTION: Abuse or use of a hose outside the manufacturers recommended conditions may cause it to quickly
deteriorate and become a safety hazard. This could result in serious injury or property damage. Inspect and test
hose assemblies frequently.
Assembled
Tool
Additional Battery
Pack
Battery Charger
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925
Warranty
http://www.band-it-idex.com/warranty.html

Safety Guidelines

Contents
www.BAND-IT-IDEX.com
Page 2 of 14
UL4000-B
UL4000-B220
®
Ultra-Lok
Parts List
• Assembled Tool
• Battery Charger
• Additional Battery Pack
• Syringe Pouch
• Hex Key, 5/32"
• Hex Key, 3/16"
• Manuals, Tool & Drill
• Carrying Case
Document # P07986 Rev. F
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
Tool

Advertisement

Table of Contents
loading

Table of Contents