ABB LS4000 Operating Instructions Manual page 197

Installation –
Process Parameters
menu
Installation –
Installation Flanges
menu
Installation –
Ambient conditions
menu
Installation –
External inputs menu
Installation –
Channels menu
LS4000, LS4060 DIODE LASER ANALYZERS | OI/LS4000/O2-EN REV. A
Make the following settings:
Process path length
Pressure input
Temperature input
Fixed pressure level
Fixed temperature level
Enable process broadening
Step Procedure
3 Leave the other settings unchanged.
4 Click on "Next".
The "Installation – Installation Flanges" menu is displayed.
Make the following settings:
Total flange path length
Concentration in flanges
Step Procedure
5 Leave the other settings unchanged.
6 Click on "Next".
The "Installation – Ambient conditions" menu is displayed.
Step Procedure
7 Leave all values unchanged.
8 Click on "Next".
The "Installation – External inputs" menu is displayed.
Step Procedure
9 Leave all values unchanged.
10 Click on "Next".
The "Installation – Channels" menu is displayed.
Step Procedure
11 Leave all values unchanged.
12 Click on "Next".
The "Installation – Analog and Digital outputs" menu is displayed.
0.7 m
FIXED
FIXED
Enter value of the ambient pres-
sure
Enter value of the ambient tem-
perature
No
0 (zero) m
0 (zero) %
197