Makita GF600 Instruction Manual page 5

Power source
disposal:
— do not expose to sunlight and to tempera-
tures exceeding 50°C (122°F);
— do not smoke;
all of the fasteners:
— when unattended;
— before performing any maintenance or
repair;
— before moving the tool to a new location.
Operational safety
inside the tool that can be dangerous if a crack is
caused by rough handling (dropping or striking).
Do not attempt to carve or engrave on the tool.
something wrong or out of the ordinary with the
used.
tion port area.
whether it contains fasteners or not.
tool carefully.
trigger or hand it to someone in this condition.
— when changing one driving location to
e.g. roof laths;
— closing boxes or crates;
vehicles and wagons.
It is not designed for electric cable installation
and may damage the insulation of electric cables
the tool. Make sure there is no one below when
working in high locations to prevent danger if there
as you move forward. It is easy to lose your footing
-
if you drive fasteners while inching backward. When
work from the top to the bottom. You can perform
driving operations with less fatigue by doing so.
ers with care.
inside and outside at the same time. Fasteners
danger.
Service
Lubricate moving parts to prevent rusting and
minimize friction-related wear. Wipe off all dust
from the parts.
inspection of the tool.
maintenance and repairs should be performed by
Makita replacement parts.
SAVE THESE INSTRUCTIONS.
-
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all instruc-
tions and cautionary markings on (1) battery
charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may
result in a risk of overheating, possible burns
and even an explosion.
If electrolyte gets into your eyes, rinse them
out with clear water and seek medical atten-
tion right away. It may result in loss of your
eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any con-
ductive material.
5 ENGLISH
-