Configuring Vflash Sd Card - Dell USC User Manual

8 In the Additional Settings page, select the Secure Virtual Disk box and
click Next.
The Summary Page is displayed with details of the virtual disk attributes.
9 Click Finish.
10 To verify the virtual disk creation, repeat the first two steps.

Configuring vFlash SD Card

Use this feature to enable or disable the vFlash SD card, check the health and
properties, and initialize the vFlash SD card. The Dell vFlash SD card enables
the part replacement feature. USC-LCE support vFlash SD cards of sizes 1
GB, 2 GB, or 8 GB.
NOTE:
The options under vFlash SD card are grayed-out if there is no SD card
inserted in the slot.
See the Integrated Dell Remote Access Controller 6 (iDRAC6) User's Guide
available at support.dell.com/manuals for more information on vFlash SD
card and the installation procedure.
Use the vFlash SD Card Configuration to:
• Enable/disable vFlash SD card.
• Determine the vFlash SD card properties:
– Name
– Health
Table 4-12. Health Status and Response Action
Health State
OK
Warning
Critical
– Size - Indicates the total size of the vFlash SD card.
– Available Space - Indicates the available size on the vFlash SD card to
create a new partition.
Response Action
None
Initialize and try again
Remove, reset, and try again
Initialize and try again
USC and USC-LCE Operations
81