View Current Configuration; Select Raid Controller - Dell USC User Manual

Foreign Configuration Found
c
Express or Advanced Wizard
d
Select Basic Settings
e
Express Wizard Only - Assign a Hot Spare
f
Express Wizard Only - Review Summary
g
Advanced Wizard Only - Select Physical Disks
h
Advanced Wizard Only - Additional Settings
i
Advanced Wizard Only - Review Summary
j

View Current Configuration

The View Current Configuration page displays the attributes of
any virtual disks already configured on the supported RAID controllers
attached to the system. You have two options:
• Accept the existing virtual disks without making changes. To select this
option, click Back. If you intend to install the operating system on an
existing virtual disk, ensure that the virtual disk size and RAID level are
appropriate.
Use the RAID configuration wizard to delete all the existing virtual disks
•
and create a single and new virtual disk to be used as the new boot device.
To select this option, click Next.
NOTE:
data redundancy and may enable you to reconstruct data in the event of a
disk failure.
NOTE:
multiple virtual disks, use Option ROM. To access Option ROM, press CTRL+R.

Select RAID Controller

The Select RAID Controller screen displays all supported RAID controllers
attached to the system. Select the RAID controller on which you want to
create the virtual disk, and then click Next.
RAID 0 does not provide data redundancy. Other RAID levels provide
You can create only one virtual disk using USC or USC-LCE. To create
USC and USC-LCE Operations
71