Dell USC User Manual page 114

Table 5-3. USC-LCE Error Messages and Resolutions
Error Message
Failed to copy to Network
Share
Failed to log the message
Failed to Open Dell Update
Package File
Invalid USB Folder
Location
Invalid Network Share
Folder Location
Invalid USB and Network
Share Folder Location
Failed to copy to USB
Device. Destination folder
not present
Failed to copy to Network
Share. Destination folder
not present
The Update Package is not
supported for this System
Invalid Update Package
The backup operation that
was initiated from USC
completed with errors. For
more information, refer to
the RAC log.
Initiating backup failed.
Retry after few minutes.
Copying backup file to the
SRVCNF partition on the
vFlash SD card failed.'
114
Troubleshooting and Frequently Asked Questions
Resolution
This error may occur due to temporary network
problems. If this issue persists, check the network
connection and then retry.
Ensure that these characters are not used in the 
message: <, >, &, and %. If the issue persists, reboot
iDRAC.
Use the correct DUP , name, and path.
Provide the valid folder location.
Provide the valid folder location.
Provide the valid folder location.
Ensure that the folder exits, or create the folder and
retry.
Ensure that the folder exists, or create a folder and retry.
Ensure that the DUP is supported on the system.
Ensure that the DUP is not corrupt or tampered.
The RAC log contains the names of the components
that failed during backup. Verify the firmware
information and retry.
Perform A/C power cycle and retry.
Make sure that the vFlash SD card is installed,
initialised, and enabled.
(continued)