Figure 71. Reconnecting the B-Side Cable to the Remaining Expansion Enclosure
1
Storage system
3
Storage controller 2
5
Expansion enclosure 1
Disconnect the SCv360 Expansion Enclosure from the A-Side
of the Chain
Disconnect the A-side cables from the expansion enclosure that you want to remove.
1
Disconnect the A-side cable (shown in orange) from expansion enclosure 1: left EMM, port 1. The B-side cables continue to carry I/O
while the A-side is disconnected.
2
Remove the A-side cable between expansion enclosure 1: left EMM, port 3 and expansion enclosure 2: left EMM, port 1.
2
Storage controller 1
4
Disconnected expansion enclosure
Adding or Removing Expansion Enclosures
89