Replacing The Fuses - PeakTech 3445 Operation Manual

7. Replacing the fuses

Warning:
To avoid electric shock, disconnect the test leads from any source of
voltage before removing the back cover or the battery/fuse door.
1. Turn the screw on the battery compartment half a turn counter-
clockwise to open the battery compartment.
3. Remove the blown fuse from the fuse holder.
4. Insert the new fuse into the fuse holder - appropriate to the value
and the dimensions of the original fuse. Make sure that the fuse
is centred in the holder.
5. After replacing the appropriate backup, attach the battery cover
back to the device and secure it by turning the screw by half a
turn clockwise
Warning:
To avoid electric shock, do not operate your
meter until the back cover and the battery
door is in place and fastened securely
Note:
If your meter does not work properly, check
the fuses and battery to make sure that
they are still good and properly inserted.
800mA/1000V F (fast acting) 6,3 x 32mm
10 A/1000V F (fast acting) 10 x 38 mm
-73-