WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
WARNING:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
CAUTION:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin can
reduce the heat transfer capability of the thermal grease.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1
Remove the
base
cover.
2
Remove the
I/O-board
interposers.
Procedure
1
Peel the tape that secures the heat-sink shield to the system board.
2
Using a plastic scribe, release the heat-sink shield from the slots on the system board.
3
Lift the heat-sink shield off the system board.
4
In reverse sequential order (as indicated on the heat sink), remove the four screws (M2x3) that secure the heat sink to the system
board.
computer. After working inside your computer, follow the instructions in
Removing the heat sink
www.dell.com/
9
After working inside
Removing the heat sink
25