Changing The Controller's Parameter Settings - Omega BB701 User Manual

Only the boldface parameters are active for the default mod of operation. The other
parameters are not valid for operation with the BB701. They are only listed for the
sake of complete documentation of the controller.
1. Press the
alternately display the menu level and "Ac.Cd."
2. Use the
3. Once you have chosen the desired menu use the
parameters. To change the setting of a given parameter, use the
keys.
4. To save settings press the
menu and return to the normal operating mode.
5. To change settings on other menu levels, you must re-enter the
programming menu (from step #1).
3.5 Heat-Up/Cool-Down Cycle Transition Times
The following table shows the amount of time required to change the target plate
temperature from one setpoint to another. The starting temperature is shown
along the left side. The final temperature is shown along the top. All transition
times are approximate.
-18ºC
37.8ºC
93.3ºC
148.9ºC
Menu 00
Key Lock
key to enter the programming mode. The lower display will
and keys to change to the desired menu level.
key. The controller now exits the programming
Figure 6. Changing the Controller's Parameter Settings
-18ºC
0ºF
0ºF
0ºC 32ºF 6.0 min.
100ºF 13.5 min. 3.0 min.
200ºF 21.5 min. 7.0 min. 3.0 min.
300ºF 22.0 min. 8.5 min. 4.5 min. 2.5 min.
Figure 7. Heat Up/Cool Down Transition Time Table Menu 01
SETPOINT
Ac.Cd
NOTE:
key to scroll through the
FINAL TEMPERATURE
0ºC 378ºC 93.3ºC
32ºF 100ºF 200ºF
1.5 min. 2.0 min. 3.0 min. 7.0 min.
1.5 min. 3 min.
2.5 min. 6.5 min.
Menu 02 Menu 03
Ac.Cd = 02 Ac.Cd = 03
Gn.o 128 ALr1
Gr.o2 1.1 ALr2
rAtE 03 Cy.t1
rSEt 12 Cy.t2
H.Hys SP.tt
HyS.1 L.SP.L
C.HyS L.SCL
HyS.2 U.SP.L
C.SPr H.SCL
SPr.2
3
BB701
and
148.9ºC
300ºF
7 min.
5.0 min.
Menu 04
Ac.Cd = 04
id.no 01
bAUd 12.o.7
00 CAL.L
00 CAL.H
OFF
0.0
3-5
300.0
Menu 0
Ac.Cd = 0
SnSr d
Sn.00
dEC.P
FILt
OUt.1 H
OUt.2 C
CoL.t n
A1.HL H
A1.Pd P
A1.OP O