Object Library Details (Objects In The 1000S); Writing Command To Eep-Rom (1010H) - Mitsubishi Electric MELSERVO-JE MR-JE-C Instruction Manual

6. MODBUS REGISTERS

6.2 Object library details (objects in the 1000s)

6.2.1 Writing command to EEP-ROM (1010h)

For the objects that can be saved, write "65766173h" (= reverse order of the ASCII code of "save") to the
corresponding sub object of the writing command to EEP-ROM (Store Parameters) (1010h) to store the
object in the EEP-ROM of the servo amplifier.
The value saved in the EEP-ROM is set to the object at the next power-on. Servo parameters can also be
modified through the object library. However, the new setting is not automatically written to the EEP-ROM.
To write the new setting, use the writing command to EEP-ROM (Store Parameters) (1010h).
Executing the writing command to EEP-ROM (Store Parameters) (1010h) takes about a maximum of 10 s
because all parameters are written at the same time. Be careful not to shut off the power during writing.
Address
Writing command to EEP-
1010h
ROM (Store parameters)
Parameter setting values can be saved in EEP-ROM.
POINT
This section describes the objects in the 1000s. Refer to section 6.1 for details
on the objects not listed here.
POINT
Before shutting off the power after executing the writing command to EEP-ROM
(Store Parameters), always check that parameters are not being saved (Bit 0 is
on).
Name
Number of entries
(Number of entries)
Restoring all default parameters
(Restore all default parameters)
Data Read/
type write
1 bytes Reading
Read/
4 bytes
write
6 - 17
No. of Points/ Continuous read/
No. of Registers continuous write
3 Impossible