System Menu - ADJ ikon profile ww User Instructions

SYSTEM MENU

System Menu
SYSTEM MENU
On-Board System Menu. The Ikon Profile WW comes with an easy to navigate system menu. This next
section will detail the functions of each command in the system menu. Please read the next section
thoroughly!
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach function
you wish to change. When you reach the function you wish to change press the enter button. When a function
is selected use the UP or Down buttons to change the function settings. Once your changes are made press
the enter button, and then press and hold the MENU button for at least three seconds to confirm and lock the
change into the system memory. If the menu button is not pressed and held within eight seconds the fixture
will automatically confirm and lock the change into the system memory. To exit without making any changes
press the MENU button.
ADDR
- DMX Address Setting.
1. Press the MENU button until "ADDR" is displayed, press ENTER.
2. The current DMX address will now be displayed and flashing. Press the UP or DOWN buttons to find your
desired address. Press ENTER to set your desired DMX address.
NOTE: If after you connect your DMX controller the unit does not fall into DMX mode, press and hold the
MENU button for at least 3 seconds.
SLND
- This will let you set unit as a master or slave in a master/slave configuration.
1. Press the MENU button until "SLND" is displayed, press ENTER. "MAST" or "SL 1" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, press ENTER to confim and exit.
A.D.J. Supply Europe B.V. – www.americandj.eu – Ikon Profile WW Instruction Manual
DMX Address
Slave Mode
DMX Last State
Dimmer Mode
Back Light
Display
Manual Test
Auto Test
Fixture Temperature
Fixture Hours
Software Version
Page 6