Removing The Front Bezel - Hitachi AMS 2100 Hardware Manual

Removing the front bezel

Complete the following steps to remove the front bezel.
CAUTION! Attach and remove the front bezel carefully. Otherwise,
you may pinch your fingers between the bezel and the chassis as
it snaps closed.
NOTE: The front bezels of the RKS/RKES/RKM/RKEM, the RKAK, and the
RKAKS are different sizes.
NOTE: When installing or removing the front bezel, be careful not to
operate the main switch or the ON/OFF button of the front bezel.
1. Unlock the front bezel. The key stays in the lock while it is unlocked.
NOTE:
it, the key and/or the lock may be damaged when attempting to turn the
key.
NOTE:
groove with the positioning mark on the lock. If the key is not aligned
properly, the lock may be damaged.
2. Grasp the front bezel on both sides and above the center of the unit. Pull
the front bezel toward you to disengage it from the ball catches.
3. Disengage the two hooks of the front bezel from the slots on the array
chassis by shifting the bezel to the left, and remove the bezel. See
Figure
5–28
If the key is not inserted all the way into the lock before turning
When you remove the key after locking the front bezel, align its
Figure 5-25: Front Bezel Key
5-26. Also, see the illustrations in Chapter 4 for more details.
Installation
Hitachi AMS 2100/2300 Storage System Hardware Guide