Power Off The Device; Reset The Configuration; Next Steps - Juniper SRX300 Manual

Hide thumbs Also See for SRX300:
Table of Contents

Advertisement

Power Off the Device

You can power off the device in one of the following ways:
• Graceful shutdown—Press and immediately release the Power button.
• Forced shutdown—Press the Power button, and hold it for 10 seconds.
After powering off a power supply, wait at least 60 seconds before turning it
back on.

Reset the Configuration

Use the RESET CONFIG button to restore the device to the factory-default
configuration or to a rescue configuration. To press the RESET CONFIG button,
insert a small probe (such as a straightened paper clip) into the pinhole on the
front panel.
Pressing and quickly releasing the RESET CONFIG button loads and commits
the rescue configuration. The rescue configuration is a previously committed,
valid configuration set through J-Web or the CLI. The STATUS LED is solid amber
during this time.
Pressing and holding the RESET CONFIG button for 15 seconds or more,
until the STATUS LED is solid amber, deletes all configurations (backup
configurations and rescue configuration), and loads and commits the factory
configuration.
NOTE:
After resetting the device, check the device status by viewing
the LEDs on the front panel. For information on the LED states, see the
"Power On the Device" section.

Next Steps

For information on configuring features on your services gateway, refer to the
following:
• Junos OS Documentation/Feature Configuration
http://www.juniper.net/techpubs/en_US/release-independent/junos/
information-products/pathway-pages/srx-series/product/index.html
• Getting Started Knowledge Base Article
https://kb.juniper.net/InfoCenter/index?page=content&id=KB15694
Reference
Technical Support
http://www.juniper.net/support/requesting-support.html
SRX300 Services Gateway Hardware Guide
http://www.juniper.net/techpubs/en_US/release-independent/junos/
information-products/pathway-pages/hardware/srx300/index.html
Supported Transceivers
https://pathfinder.juniper.net/hct/product/#prd=SRX300
How to Set Up Your SRX300 Services Gateway
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents