Connect The Grounding Cable; Power On The Device - Juniper SRX340 How To Set Up

4. Install the second screw in each mounting bracket.
5. Verify that the mounting screws on one side of the rack are aligned with the
mounting screws on the opposite side and that the device is level

Connect the Grounding Cable

1. Attach an ESD strap to an ESD point and place the other end of the strap
around your bare wrist.
2. Connect the grounding cable to a proper earth ground. Place the grounding
cable lug over the grounding point on the side of the chassis.
3. Secure the grounding cable lug to the grounding point with the screws.

Power On the Device

NOTE:
strap to an ESD point and place the other end of the strap around your
bare wrist.
1. Insert the appliance coupler end of the power cord into the appliance inlet on
the power supply faceplate.
2. Insert the power cord plug into an external AC power source receptacle.
How to Set Up Your SRX340 Services Gateway
NOTE: The device should be permanently connected to ground during
normal operation. A licensed electrician must attach a cable lug to the
grounding cable. A cable with an incorrectly attached lug can damage
the device.
Before connecting the device to the power supply, attach an ESD
3