Power Off The Device - Juniper SRX345 How To Set Up

Verify the Settings
Access http://www.juniper.net to ensure that you are connected to the Internet.
This connectivity ensures that you can pass traffic through the services gateway.
If the page does not load, perform the following checks to see if you can identify
the problem:
• Verify your configuration settings, and ensure that you have applied the
con figuration.
• Check if the ISP-supplied device connecting your SRX Series device to the
Internet is turned on and working properly. Try turning it off and on again.
After you complete these steps, the SRX Series device can pass traffic from any
trust port to the untrust port.
NOTE: With this step, you have successfully completed the initial
configuration, and your SRX345 Services Gateway is ready for use.
Change the Configuration Settings (Optional)
After you complete the initial setup configuration, you can access the J-Web
setup wizard by clicking Configure > Device Setup > Set Up. You can either
edit the existing settings or create a new configuration. If you choose to create
a new configuration, then all the current configuration in the services gateway
will be deleted.

Power Off the Device

You can power off the device in one of the following ways:
• Graceful shutdown—Press and immediately release the Power button.
• Forced shutdown—Press the Power button, and hold it for 10 seconds.
After powering off a power supply, wait at least 60 seconds before turning it
back on.
How to Set Up Your SRX345 Services Gateway
8