Battery Replacement - Extech Instruments EC210 User Manual

Battery Replacement
The 9V battery that powers the instrument requires replacing when the battery icon flashes on
the display. To replace the battery follow the steps below:
1.
Disconnect the probe from the instrument.
2.
Open the rear battery compartment using a screwdriver to remove the two Phillips head
screws that secure the compartment.
3.
Carefully remove the old battery from the compartment lid chamber and gently unsnap
the battery's terminals from the wired (red/black) connectors.
4.
Install a new 9V battery by snapping the battery terminals onto the wired connectors
(observing correct polarity) and inserting the battery into the compartment lid chamber.
5.
Install the compartment lid chamber into the meter housing and secure with the two
screws.
Never dispose of used batteries or rechargeable batteries in household waste.
As consumers, users are legally required to take used batteries to appropriate
collection sites, the retail store where the batteries were purchased, or wherever
batteries are sold.
Disposal: Do not dispose of this instrument in household waste. The user is obligated to take
end‐of‐life devices to a designated collection point for the disposal of electrical and electronic
equipment.
7 EC210-en-GB_V1.1 11/14