Test Run - Grizzly G0773 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Make sure all tools and objects used during
setup are cleared away from machine.
2. Press Emergency Stop button cover (see
Figure 17) to prevent unexpected start up.
Spindle Direction
Switch
Lathe Power Light
Emergency
Stop Button
Cover
Lathe/Mill
Selector Switch
Figure 17. Headstock controls.
-24-
3. Set spindle direction switch to OFF position.
4. Set lathe/mill selector switch to "1".
5. Make sure chuck and jaws, if installed, are
secure (see Chuck Installation on Page 28).
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test run.
6. Disengage half nut with lever by positioning
lever as shown in Figure 18.
Engaged
Figure 18. Half nut lever positioned to disengage
half nut.
7.
Connect machine to power. Lathe power light
(Figure 17) should illuminate if machine is
correctly connected to power supply and all
electrical controls are positioned correctly for
startup.
Model G0773 (Mfd. Since 4/17)
Half Nut
Lever
Disengaged