Table of Contents
Advertisement
Installing/Removing
Tooling
Cutting tools are sharp and
can easily cause cutting
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Installing Tooling
Tools Needed
Wrench 17mm.................................................... 1
Spindle Locking Pin ........................................... 1
To install tooling:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove drawbar cap (see Figure 89).
Figure 89. Location of drawbar cap.
-54-
Qty
Drawbar Cap
3.
Insert tooling (not included) into spindle until
in contacts drawbar.
4.
Working from the top, thread drawbar by
hand into tooling until snug (see Figure 90).
Figure 90. Threading drawbar into tooling.
5.
Insert spindle locking pin into hole in spindle,
and tighten drawbar, as shown in Figure 91.
Note:
Do
not
Overtightening makes tool removal difficult
and may damage arbor and threads.
Figure 91. Tightening drawbar lock nut.
6.
Re-install drawbar cap.
Model G0773 (Mfd. Since 4/17)
overtighten
drawbar.
Spindle
Locking Pin
Advertisement
Table of Contents
