By-Pass And Rearming Of Zone; Variation Of Telephone Number - AVS Electronics CAPTURE User Manual

By-pass and Rearming of zone

When the system is off, you can make the exclusion zone.
There are two possible ways to exclude a zone; for one of them it is necessary to remind the
number of zone to exclude/include; for the other one it is necessary to look through the menu of
the reference zones to exclude/include
Example: Zone 2 must be by passed.

Digit User Code
Note: if the user code is associated to multiple sectors and the "Skip sector selection" option is
not active, you will be asked to select the sector to work in.

Press the (ZONE) "OFF-ZONE" key - (0)
1° mode (a):
a
Press the key corresponding to the number of the zone to be by passed
a
Press (ENT) key to confirm
a
Press (ESC) key to exit
2° mode (b):
b
Look through the list of the reference zones until reaching the one you wish ()
b
Press (ENT) key to confirm,
b
Press (ESC) key to exit

The display will show which zone has been by passed and the green OK Led will begin
flashing in order to indicate that the zone has been by passed.
In order to un by pass the zone(s) by passed, the same procedure used for zone by passing must
be used.

Variation of telephone number

When the control panel is off, it is possible to change the telephone numbers.

Digit User Code
Note: if the user code is associated to multiple sectors and the "Skip sector selection" option is
not active, you will be asked to select the sector to work in.

Press (1)

Press () repeatedly to the "Number telephone" step and then press (ENT)

Press (CLR), select memory position (1)..(16) and (ENT)

Press (CLR), the (new telephone number) and (ENT)

Press (ESC) to exit
Any change of telephone numbers must be followed by a total test of the system.
Note: It is possible to vary the concerned telephone numbers and the vocal and SMS ones only.
- 17 -