User Codes; Variation Of User Codes; Master User Codes; Changing Or Erasing User Codes - AVS Electronics CAPTURE User Manual

User Codes

The User Code allows the user to inter-act with the system to arm/disarm the system and to
make other operations
This code is strictly personal ad secret, it is recommended not to divulge it for security reasons.
The user code is made of 4 to 5 digits, followed by pushbutton ENT in order to be recognized or
it can be made of 6 digits, in this case it is not necessary to press ENT
The flexibility of the user code allows the installer to vary the settings according to system po-
tential, with no risk for security.

Variation of User Codes

When the control panel is off, it is possible change the User Code:
Nota: if the User code is associated to all sectors, digit the sector.

Enter the User Code

Press the (1) "CODE" key followed by the (ENT) key

Press (CLR), digit the new User code

Press (ENT) to confirm

Press (ESC) to exit
All the functions can be entered now only with the use of the new code.
Remember that if the User Code is forgotten it can obviously not be varied.

Master User Codes

The Master User option, in addition to the functions of the user code assigned in the relative user
profile allows the user to change the User (NOT MASTER) Codes associated with its own sectors,
to change the string and to block the ability of operating from the keypad and RTC while leaving
the keys and remotes associated to them active.

Changing or Erasing User Codes

You can change the User Codes with the system off.

Enter the User Code
Note: if the user code is associated to multiple sectors and the "Skip sector selection" option is
not active, you will be asked to select the sector to work in.

Press the (1) "CODE" key followed by the (ENT) key

Press (CLR) followed by the number of the user code to be changed and press (ENT)

a
To change the User code, press (CLR), enter the new Code and then press (ENT)

b
To erase the User Code, press (CLR) two times and then (ENT)
• In this way the code will is disabled for working from the keypad and RTC while the
keys and remotes associated to the Code remain active.

Press (ESC) to exit
- 11 -