Problem Identification - GGP ITALY SPA MP 84 Series Operator's Manual

Operation
ENGINE
Checking/topping up fuel level
Check/top-up engine oil
Replacement of the engine oil
Air filter cleaning and check
Air filter replacement
Fuel filter check
Fuel filter replacement
Spark plug points cleaning and check
Replace the spark plug
* See the engine manual for the full list and frequency
** At the first signs of any malfunction, contact your Dealer immediately
*** The operation must be carried out by your Dealer or a specialized Service Centre
*** General lubrication of all joints should also be carried out whenever
the machine is to be left unused for a long period.

14. PROBLEM IDENTIFICATION

PROBLEM
1. With the key turned to
«ON», the light stays
off (for rear collection
models only
2. With the key turned
to «START» the light
flashes and the starter
motor does not run
(for rear collection
models only)
3. With the key turned
to «START» the light
is on but the starter
motor does not run
(for rear collection
models only)
If problems persist after having performed the above operations, contact your dealer.
Frequency
(hours)
Before
each use
Before
each use
...
...
...
...
...
...
...
PROBABLE CAUSE
The safety device of the electronic
circuit board has cut in due to:
badly connected battery
battery terminals crossed
flat battery
fuse blown
wet circuit board
starting conditions have not been met
insufficiently charged battery
malfunction on the starter relay
Completed (Date or Hours)
Turn the ignition key to «STOP» position
and look for the cause of the problem:
check the connections (par. 4.4)
check the connections (par. 4.4).
recharge the battery (par. 7.5)
replace fuse (10 A) (par. 8.5).
dry using luke warm air
check that all starting conditions are met
(par. 6.2.2)
recharge the battery (par. 7.5)
contact your Dealer
EN - 22
Notes
par 7.2
par 7.3
*
*
*
*
*
*
*
REMEDY