Huawei OceanStor VIS6300 Quick Installation Manual page 34

a
Connect One End of the Network Cable to the Port of the
Ethernet Switch
b
Laying Network Cables
For details on outside the cabinet wiring of network cables (overhead wiring and underfloor wiring) from
the Ethernet switch to the maintenance terminal, see the appendix.
c
Connect the Other End of the Network Cable to the Network
Port of the Maintenance Terminal
If the maintenance terminal is connected to the configuration network port of the VIS6000, it cannot
provide a network port to connect the management network port. In this case, perform this operation after
setting the IP addresses of the management network ports of controller A and controller B and
disconnecting the configuration network port of the VIS6000 from the maintenance terminal.
33